Installation guide

Installation
Built-In Microwave/Convection Oven
hl,stallation
Options
These built-in ()veils can be inset into the
cabinetry. In this installation tire microwave is
recessed and flush with tire flxmt surfilce of
the cabinet.
A shadow box affect can be achiex ed bv
installing a rail at tire top and bottom of tire
micro_ax e to fill the cutout height, In this
installation, exposed inside surfilces of the
cabinet should be finished to match the
cabinet surfilce.
• In both a recessed and shadow box
installation, the floor of the cutout must be
level and even with the bottom edge of the
cutout. Use rmmers inside tire opening to
raise the floor to matching height.
...........J
Top
Rail
Bottom
Rail
.... _. Sq.
StopperStrip4 sides
Inset/Recessed Installation
• Cut 4 stopper strip s, 13/16" square to fl'ame
the opening, install the strips 13/16" fl'om
the fl'ont edge of the opening. Oven overlap
will cover all 4 stopper strips.
Shadow Box Installation
• Cut top and bottom rail to fit the width of
the opening. Cut the height of the rails to fit
the cutout height. Use cleats to secure the
rails to the inside walls of the cabinets.
Tools and Materials required:
• #2, Phillips screwdriver
• Hand held drill motor
• High speeddrill bit, 1/8"
diameter
• 2 each#8x1"- Roundhead
wood screws
• 3/8", slothead screwdriver
Parts supplied:
• 2 mounting screws
• 4 extra side trim screws
• 2 side trim pieces
Ste 1
SS:de the
Mioowave
into Cutout
• Lift and hold the oven up to the opening.
• Hold the oven at the 45 ° angle and plug in
the power cord.
• Carefiflly, slide the oven into the cabinet.
• Check to be sm'e that power cord is not
trapped under the bottom or the sides of the
()veil,