Installation guide

mnstaJiation mnstructions

F_ iNSTALL THE ANTbTJP BRACKET

[_ l_)raw a lim_e o]_ the cutola {loot at the ce]_ter of

the claouL amid exteN_d the lim_e _" dow_ the f_ce

of the cabim_et.

_Fo]d or c_t the f_ont edge of the template, a](mg

the {_ont g_fide ]h_e_ Place the template fi_sh

aiding the f_<mt edge of the cl_tol_t floo_; a]]gn]m_g

the cellter ]im_e of the template _it]l the cellter ]im_e

of the clltoIlt {loot. Mark the cel/ters of the t_ko

scre_ holes _ith am_ a_] or ce_ter preach f_)r the

am_ti-ti I) bracket ]ocatiol_ as showl_.

Cutout Floor

[]Remove the template amid drill two holes for the

Screws

' I

Anti-Tip Bracket

[] Ira/stall the bracket the flooram/[i-[ip

(H/[O CIKtHK

Hsi_/ _ two bro_/ze roH_/d-]/ead screws.

1-_ INSTALL MICROWAVE OVEN

INTO CABINET

[_ Slide [lie microwa',e o',en part wa_ into [lie cabinet

Dizening.

[]Plug in the microwaxe oxen.

Bottom Duct sernbly

Anti-Tip

Bracket

[]

Bottom Bracket

The bottom bracket must be fiat to the cutout

floor to engage correctly with the anti-tip bracket

as shown. Carefllllv slide the microwave oven back,

engaging the anti-tip bracket. Make sure the

power cord is not mashed or cut as you slide the

microwave into place.

Center the microwaxe oxen within the

ct/to/It ol)ening,.

Ensure the microwaxe o_en is accurately centered.

I,ine up the center line on the cabinet with the

triangular hole on the front of the bottom duct,

Opening

Screws _"

\ Flange

_ Drill pilot holes through the positioning flange

and then install fixe bronze round-head screws

at the front of the bottom duct as shown.