Use and Care Manual

2
OPERATION
To receive filtered water, open the water supply.
FILTER CARTRIDGE REPLACEMENT
1. Turn off the water to the filtration system.
2. Firmly hold the shower filter housing turning counter
clockwise to remove filter.
3. Pull out used filter cartridge straight out and discard.
4. Insert new Filter Cartridge into the filter shower base
5. Put the housing back on the base by turning clockwise,
hand tightening until secure.
6. Slowly turn on the water and check for leaks.
7. Flush unit by allowing water to flow through for a few
minutes, until water clears.
NOTE: When the filter is used for the first time, some carbon
fines may appear in the water.
TROUBLESHOOTING
Troubleshooting Tips
Save time and review the table below before calling for service.
Problem Possible Causes Solution
Shower filter unit will not stay in
position
Swivel collar is not tight enough. Tighten the swivel collar.
Leaking around the shower pipe area Swivel collar is not tight enough. Tighten the swivel collar.
Gasket is not seated in the swivel
collar.
Make sure the gasket is seated in the
swivel collar, then tighten the swivel
collar.
Housing leaking Filter housing not secured to the base. Make sure housing is securely attached
to the base.
Missing O-ring on filter housing. Return to the store.
Filter cartridge housing fits loosely
to the base
Missing O-ring on replacement filter. Return to the store.
Leaking around shower head Missing gasket in shower. Use Teflon
®
Tape on shower filter
threads.
CLEANING THE SYSTEM
Use a damp cloth and mild soap for cleaning. Do not use
harsh chemicals, detergents, abrasives, solvents or
cleaning fluids, since they will damage the system.
O-ring
Filter base
Filter cartridge
Filter housing
O-ring
Remove the label