Manual

About the water softener system.
Service: Manually Advance Recharge Check
NOTE:The control display must show a steady
time (not flashing).
I. Press the RECHARGE @ button and hold in
fin" three seconds. RECHARGE NOWbegins to
flash as tile water soDening system enters tile
fill cycle of recharge. Remove the brinewell
cover and, using a flashlight, observe fill
water entering tile brine tank. If water does
not enter tile tank, look fl)r an obstructed
nozzle, venturi, fill flow plug or brine tubing.
See Care and Cleaning of the Water Softener
System section.
2.ADer obser\ing fill, press tile RECHARGE @
button to move tile water softening system
into brining. A slow flow of water to the drain
will begin. Veritk' brine draw fl'om tile brine
tank by shining a flashlight into the brinewell
and observing a noticeable drop in the liquid
level over an extended period of time.
NOTE: Be sm'e a salt bridge is not preventing
water fl'om contacting salt. See Care and
cleaning of the water softening system section.
If the water softening system does not draw brine,
check:
i_i' nozzle and/or venttlri dirty or deflective.
N defective nozzle and venmri seal.
_: nozzle and venturi not seated propedy
on gasket.
_: other inner wdve defect (rotor seal, rotor
and disc, wave washe_; etc.).
::Ji::restricted drain (check drain fitting and
hose).
NOTE:If water system pressure is low, an
elevated drain hose may cause back pressure,
stopping brine draw.
3.Again, press tile RECHARGE@ button to ino_,e
tile water soDening system into backwash.
I,ook for a fhst flow of water fl'om tile drain
hose. A slow flow indicates a plugged top
distributor, backwash flow i_lug or drain hose.
4. Press tile RECHARGE@ button to Inove tile
water soDening s):stem into tast rinse. Again
look for a tast drain flow. Allow the water
soDening system to rinse for a few minutes
to flush out any brine that mav remain in
the resin tank fl'om the brining cycle test.
5. To return tile water soDening system to
set\ice, press tile RECHARGE @ button.
16