Manual

GEAppliances.com
Service: Manually Initiated Electronics Diagnostics
I. To enter diagnostics, press and hold the
MODE button until (000 --) shows in the
display.
A The fixst 3 digits indicate water meter
operation as fi)llo_:s:
_: 000 (steady) = soft water not in
use...no flow through the metei:
l':neSitchesOR
Water Switch(B)
Meter(A)
--OPEN A NEARBYSOFTWATERFAUCET--
?_:000 to 199 (continual) = repeats display fin" each
gallon of water passing through the Ineter
switch
..Sensor
housing
Valye-_
outlet
support
andshaft
B
If you don't get a reading in the display; with fimcet
open, pull the sensor fl'om the wflve outlet port. Pass
a small magnet back and fi)rth in front of the sensm:
You should get a reading in the displa> If you get a
reading, shut off' water suppl B tmhook the in and Grit
plumbing and check the turbine fin" binding.
The letter (P) and dash (es) indicate POSITION switch
operation. The letter appearing ineans the switch is
closed; the dash means the switch is open. Use the
RECHARGE@ (RECHARGETONIGHT-RECHARGE NOW)
button to manually ad\ance the valve into each cycle and
check correct switch operation.
CORRECTSWITCH
DISPLAYS
Ep
VALVECYCLESTATUS
Valvein service,fill, brining, backwash
orfast rinse position.
Valverotatingfrom one positionto another
C
_._lfile in this diagnostic screen, the following infi)m_ation
is available and may be benefidal for wuious reasons.
This inlom_afion is retained by the computer fl'om the
fi_t time electrical power is applied to the control.
::Ji::Press and hold the UP button to display the mmg)er
of days this control has had electrical power applied.
?_:Press and hokl the DOWN button to display the
number cff regenerations initiated by this control
since the SR code number was entered.
2. Press the MOOEbutton and hold in three
se('on(ls until a SelM('e ]_atino (-o(le_ 5R ' ''_| |
appea_ in the display, f f
Forcorrect water softeningsystem
operation,themodelcodemustbeSR22formodelGXSF27E.
Toreset the code, press the UP or DOWN button until the
COITeCt ntllIlbeF shows.
3. Press the MODEbutton to return m the present time display,
If the code was changed, make ALL the timer settings.
NOTE"It the c(>ntrol is left in a diagnostic display (>ra
flashing display when setting times or hardness, present time
automatically retm'ns if a button is not pressed within fi)m"
minutes.
15