Manual

GEAppliances.com
Possible Causes What To Do
Interior needs cleaning. , See C_re and c/eaning.
Not unusual during periods , Wipe surface dry.
of high humidity.
Too frequent or too long
door openings.
Wine bottles touching . Reposition bottles.
the back wall.
This is normal.
Door left open.
See the Defrosting section.
Lxcesswe frost may form if the door {s left open.
See the Defrosting section.
, Door is not self-closing. Always make sure that
the door is closed after opening.
, Check to see if m bottle is holding door open.
Appliance has odor
Moisture forms on
outside of appliance
Moisture collects inside
(in humid weather,
air carries moisture
into appliance when
door is opened)
Frost forms on interior
surfaces of appliance
Q
Q
Appliance too cold Temperature control • See About the contro/ and settings,
is set too cold.
The room temperature where . For proper operation, the room temperature should
the appliance is located is be equal to or greater than the set temperature
too cold. of the appliance,
Temperature in the This is normal. . After you set the temperature, the display will go
display isnot the back to showing the actual temperature,
temperature that
was just set.
Condensation on front Appliance is located , Wipe off the condensation with a clean, dry cloth.
of door in a high humidity environment.
, Locate the appliance in o lower humidity
environment.
Wateron floor behind Door left open. , Door is not self-closing. Always make sure that
appliance the door is closed after opening,
• Check to see if u bottle is holding door open.
Tilting unit when moving. . This is normal. The drain pan above the compressor may be
full following defrost, Check to make sure
no water spills when moving the unit,
11