Full Product Manual

25
Installation Instructions
PUT THE REFRIGERATOR IN PLACE
Move the refrigerator to its final location.
4
LEVEL THE DOORS
Adjust the refrigerator door to make the doors
even at the top.
To align:
Using a 7/16” wrench, turn the door adjusting
screw to the right to raise the door, to the left
to lower it.
NOTE:
A nylon plug, imbedded in the threads of the
pin, prevents the pin from turning unless a
wrench is used.
After one or two turns of the wrench, open
and close the refrigerator door and check the
alignment at the top of the doors.
6
A
B
Doors should be even at top
Raise
7/16” wrench
LEVEL THE REFRIGERATOR
The refrigerator can be leveled by adjusting the
rollers located near the bottom hinges.
Rollers have three purposes:
• Rollers adjust so the door closes easily when
opened about halfway. (Raise the front about
5/8” [16 mm] from the floor.)
• Rollers adjust so the refrigerator is firmly
positioned on the floor and does not wobble.
• Rollers allow you to move the refrigerator
away from the wall for cleaning.
To adjust the rollers on 23‘ (33” wide), 25‘, 26‘,
27‘ and 29‘ models:
• Turn the roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise
to lower it. Use a
3/8” hex socket
or wrench, or an
adjustable wrench.
5
Rollers
Roller adjusting screw
Raise
LEVEL THE REFRIGERATOR (cont.)
To adjust the
rollers on 23
‘/25‘
CustomStyle
™
models:
Turn the front roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise to
lower it. Use a 3/8” hex
wrench with extension, or an adjustable wrench.
These models also have rear adjustable
rollers so you can align the refrigerator with
your kitchen cabinets. Use a 3/8” hex wrench
with extension to turn the screws for the rear
UROOHUV³clockwise to raise the refrigerator,
counterclockwise to lower it.
5
Roller adjusting screws