Owner's Manual
49-1000471 Rev. 1 27
INSTALLATION INSTRUCTIONS
Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
 CONNECTING THE 
REFRIGERATOR TO THE HOUSE 
WATER LINE 
(icemaker and dispenser models)
A cold water supply is required for automatic 
LFHPDNHUDQGGLVSHQVHURSHUDWLRQ,IWKHUHLV
not a cold water supply, you will need to provide 
RQH6HH³,QVWDOOLQJWKH:DWHU/LQH´VHFWLRQ
NOTES:
• Before making the connection to the 
refrigerator, be sure the refrigerator power 
cord is not plugged into the wall outlet.
,I\RXUUHIULJHUDWRUGRHVQRWKDYHDZDWHUILOWHU
we recommend installing one if your water 
supply has sand or particles that could clog 
the screen of the refrigerator’s water valve. 
,QVWDOOLWLQWKHZDWHUOLQHQHDUWKHUHIULJHUDWRU 
,IXVLQJ8QLYHUVDO:DWHU/LQH5HIULJHUDWRU
7XELQJ.LW\RXZLOOQHHGDQDGGLWLRQDOWXEH
:;;WRFRQQHFWWKHILOWHU'RQRWFXW
plastic tube to install filter.
,I\RXDUHXVLQJFRSSHUWXELQJSODFHD
compression nut and ferrule (sleeve) onto the 
end of the tubing coming from the house cold 
water supply.
,I\RXDUHXVLQJWKHXQLYHUVDOZDWHUOLQHWXELQJ
the nuts are already assembled to the tubing.
,I\RXDUHXVLQJFRSSHUWXELQJLQVHUWWKHHQG
of the tubing into the refrigerator connection, 
at the back of the refrigerator, as far as 
possible. While holding the tubing, tighten the 
fitting.
,I\RXDUHXVLQJXQLYHUVDOZDWHUOLQHWXELQJ
insert the molded end of the tubing into the 
refrigerator connection, at the back of the 
refrigerator, and tighten the compression 
nut until it is hand tight. Then tighten one 
additional turn with a wrench. Overtightening 
may cause leaks.
WARNING
Connect to potable water supply only.
A cold water supply is required for automatic 
icemaker operation. The water pressure 
must be between 40 and 120 psi (275-827 
kilopascals).
WARNING
   ELECTRIC SHOCK 
HAZARD
Attach tubing clamp using existing hole only. 
DO NOT drill into the refrigerator.
1
A
B
)DVWHQWKHWXELQJLQWRWKHFODPSSURYLGHGWR
hold it in position. You may need to pry open 
the clamp.
´7XELQJ
Tubing Clamp
´ 
Compression Nut
)HUUXOH 
(sleeve)
Universal Water Line Tubing
Refrigerator 
Connection
C
 TURN ON THE WATER SUPPLY
Turn the water on at the 
shutoff valve (house water 
supply) and check for any 
leaks.
2
 PLUG IN THE REFRIGERATOR
Before plugging in the 
refrigerator, make sure the 
icemaker power switch is set to 
WKH2))SRVLWLRQ
See the grounding information 
attached to the power cord.
3
Option 2
Option 3
Universal Water 
Line Tubing
Refrigerator 
Connection










