User Manual
30 49-60646 Rev. 7
Installation Instructions
INSTALLING THE WATER LINE (Cont.)
WHAT YOU WILL NEED (Cont.)
  NOTE: The only GE Appliances approved plastic 
tubing is that supplied in Universal Water Line 
5HIULJHUDWRU7XELQJNLWV'RQRWXVHDQ\RWKHUSODVWLF
water supply line because the line is under pressure 
at all times. Certain types of plastic will crack or 
rupture with age and cause water damage to your 
home.
•  A GE Appliances water supply kit (containing 
tubing, shutoff valve and fittings listed below) is 
available at extra cost from your dealer or from 
Parts and Accessories, 877.959.8688 (in Canada 
1.800.661.1616).
•  A cold water supply. The water pressure must be 
between 20 and 120 p.s.i. (1.4–8.1 bar).
•  Power drill.
•  1/2” or adjustable wrench.
•  Straight and Phillips blade screwdriver.
•  Two 1/4” outer diameter compression nuts and 
2 ferrules (sleeves)—to connect the copper tubing 
to the shutoff valve and the refrigerator water valve. 
OR
,I\RXDUHXVLQJD8QLYHUVDO:DWHU/LQH5HIULJHUDWRU
Tubing kit, the necessary fittings are preassembled 
to the tubing.
,I\RXUH[LVWLQJFRSSHUZDWHUOLQHKDVDIODUHGILWWLQJ
at the end, you will need an adapter (available at 
plumbing supply stores) to connect the water line to 
the refrigerator OR you can cut off the flared fitting 
with a tube cutter and then use a compression 
ILWWLQJ'RQRWFXWIRUPHGHQGIURP8QLYHUVDO:DWHU
Line Refrigerator tubing.
•  Shutoff valve to connect to the cold water line. 
The shutoff valve should have a water inlet 
ZLWKDPLQLPXPLQVLGHGLDPHWHURI´DWWKH
SRLQWRIFRQQHFWLRQWRWKH&2/':$7(5/,1(
Saddle-type shutoff valves are included in many 
water supply kits. Before purchasing, make sure 
a saddle-type valve complies with your local 
plumbing codes.
 SHUT OFF THE MAIN WATER 
SUPPLY
Turn on the nearest faucet long enough to clear 
the line of water.
 CHOOSE THE VALVE 
LOCATION
Choose a location for the valve that is easily 
DFFHVVLEOH,WLVEHVWWRFRQQHFWLQWRWKHVLGHRI
a vertical water pipe. When it is necessary to 
FRQQHFWLQWRDKRUL]RQWDOZDWHUSLSHPDNHWKH
connection to the top or side, rather than at the 
bottom, to avoid drawing off any sediment from 
the water pipe.
 DRILL THE HOLE FOR THE 
VALVE
'ULOOD´KROHLQWKHZDWHUSLSHHYHQLIXVLQJ
a self-piercing valve), using a sharp bit. Remove 
any burrs resulting from drilling the hole in the 
pipe.
Take care not to allow water to drain into the 
drill.
)DLOXUHWRGULOOD´KROHPD\UHVXOWLQUHGXFHG
ice production or smaller cubes.
1
2
3
,QVWDOOWKHVKXWRIIYDOYHRQWKHQHDUHVWIUHTXHQWO\XVHG
drinking water line.
INSTALLATION INSTRUCTIONS










