Use and Care Manual
29
Place the compression nut and ferrule (sleeve) 
for copper tubing onto the end of the tubing and 
connect it to the shutoff valve. 
Make sure the tubing is fully inserted into the 
valve. Tighten the compression nut securely.
For plastic tubing from a GE SmartConnect
™
Refrigerator Tubing kit, insert the molded end 
of the tubing into the shutoff valve and tighten 
compression nut until it is hand tight, then 
tighten one additional turn with a wrench. 
Overtightening may cause leaks.
  NOTE: Commonwealth of Massachusetts 
Plumbing Codes 248CMR shall be adhered to. 
Saddle valves are illegal and use is not permitted 
in Massachusetts. Consult with your licensed 
plumber.
 CONNECT THE TUBING TO THE VALVE
7
Saddle-Type 
Shutoff Valve
Compression Nut
Packing Nut
Outlet Valve
Ferrule (sleeve)
Turn the main water supply on and flush out the 
tubing until the water is clear.
Shut the water off at the water valve after about 
one quart (1 liter) of water has been flushed 
through the tubing.
 FLUSH OUT THE TUBING
8
Installation Instructions
SmartConnect
™
 Tubing
  Fasten the shutoff valve to the cold water pipe 
with the pipe clamp.
  NOTE: Commonwealth of Massachusetts 
Plumbing Codes 248CMR shall be adhered to. 
Saddle valves are illegal and use is not permitted 
in Massachusetts. Consult with your licensed 
plumber.
 FASTEN THE SHUTOFF VALVE
4
  Tighten the clamp screws until the sealing 
washer begins to swell. 
  NOTE: Do not overtighten or you may crush the 
tubing.
 TIGHTEN THE PIPE CLAMP
5
Pipe Clamp
Vertical Cold Water Pipe
Saddle-Type 
Shutoff Valve
Washer
Inlet End
Pipe Clamp
Clamp 
Screw
  Route the tubing between the cold water line 
and the refrigerator.
  Route the tubing through a hole drilled in the 
wall or floor (behind the refrigerator or adjacent 
base cabinet) as close to the wall as possible. 
NOTE: Be sure there is sufficient extra tubing to 
allow the refrigerator to move out from the wall 
after installation.
 ROUTE THE TUBING
6
To complete the installation of the refrigerator, go back 
to Step 1 in Installing the Refrigerator.










