Manual

InstallationInstructions.

FeedWaterAdapterandSupplyValve

D. REMOVAL AND RE-INSTALLATION OF INLET VALVE (This is only required if inlet valve needs to be removed to complete Step 5 on page 7.)

I. ]_emoxe inlet xalxe (F) fi'om adapter ((:) usino__ ac!iustable wrench on xalxe body. See Fig,..3a for details. DONOT USEWRENCHONHEX

NUTENDOFVALVEAS LEAK/IliaYOCCUR.

Fig. 3a

2. I_emove all sealing tape fl'om inlet \:flve (F) and adapter (C) threads.

3. Hand tighten assembled adapter ((:) onto supply \_flve (A) fin" the proper size installation. Be sure the gaskets (G), as shown in Fig. 1,

are in place befln'e final assembly: Finish tightening with a(!iustable wrench. Be careful notto overtighten or cross thread as damage

to threadsmay occur.

4. Using white thread sealing tape proxided, apply approximately 9 wraps of tape around the large threads on inlet _al_e (F) in a

clockwise direction, as shown in Fig . b.

5 Hand tighten inlet _al_e (F) into the adapter ((:), then finish tightening with a(!iustable wrench (see Fig . a). DO NOTUSE WRENCH

ON HEXNUT END OF VALVEAS LEAKMAY OCCUR.

FaucetSpoutInstallations(seeFig. 4,page 9)

I. I_.elnove spout (A) and timcet body (B) ti'om tauter packaging.

2. Move the threaded dome-shaped collar (C) on the spout up and m_z_yfl'om the o-rings on the spout.

3. Gently insert the spout into the top of the timcet body.

NOTE: Turning the spout left to right during installation will help the o-rings to slide in easily.

4. Once the spout (A) has been installed and fully seated, slide the threaded collar ((:) down to the thucet body (B).

5. Tighten the collar by hand to the taucet body by turning in a clockwise direction.