Manual

InstallationInstructions.
FeedWaterAdapterandSupplyValve
4. _ssemble adapter (C) and coupling (D) as shown in Fig. 1, per your configuration. Be sure the gaskets (G) are in place betore final
assembly. Start installation by hand, then finish tightening with a(!justable wrench. Be careful not toovertighten or cross thread as
damage to threadsmay occur.
Note Adapter (C) orientation:
l/2-1bch Installation--Rounded end ofadapter (C)connectsto coupling(D),then to existlbg faucettubing (B).
3/8-1hchInstallation--Rounded end of adapter(C)connectsto supplyvalve(A).
5. Hand tighten assembled adapter (C) onto supply wflve (A) for the proper size installation. Be sure the gaskets ((;), as shown
in Fig. l, are in place betore final assembly. Finish tightening with a(!justable wrench. Be careful Bet to evertightea or cross
thread as damage to threads may occur.
NOTE: If inlet valve needs to be removed to complete this step, refer to D. Removal and Reinsta//ation of Inlet Valve onpage 8.
8. Reconnect faucet tubing line (g) to top of adapter (C).
Z Remove ntlt and ferrule fl'om end of inlet valve. Using the 4 feet of tubing provided, place the ntlt (1) and ferrule (H) onto
the tubing and install onto inlet wflve (F) as shown in Fig. 9. Tighten with a(!justable wrench.
NOTE: Inspecttheon& of the tubingto be sure thereare no imperfections and end of tubingis cut square.It maybe necessan/to cut the tubingagain.
B. OPTIONALHOME INSTALLATION--SADDLE VALVE
(Whore codes permit): Saddle valve must be able to connect with 1/4-inch tubing supplied with system.
Not supplied with product; check your local hardware or home service store for product.
For I/Z" OD or larger metal robing only.
NOTE: Codes in the state of Massachusetts require installation by a licensed plumber and do not permit the use of the saddle valve.
For installation, use plumbing code 248-CMR of the Commonwealth of Massachusetts.
I. Turn oflthe cold water supply and install saddle valve as required by product selection. (Be sure to follow manufi_cmre_'
installation instructions.)
A DANGER:,f hole is required to be drilled in pipe, to protect yourself from serious injury or fatal shock, use a battery
powered hand drift only to make the hole. DO NOT USE AN ELECTRICDRILL.
Open only after complete system has been installed.
C. OPTIONALINSTALLATION
(Forinstallation with rigid pipe betweensupplyvalveand sinkfaucet)
Option I
I. Remove pipe fl'om supply wflve and sink timcet.
2. Obtain flexible pipe sized to w_ur plumbing.
3. Install flexible pipe to sink.
4. Go back to A. Preterred Installation section step 4.
Option2
I. Obtain compression fittings to fit rigid pipe.
2. Obtain any other fittings required to connect compression fittings to adaptex:
NOTE:Adapterhas I/2-inch and 3/8-inchinternal and external threads.
3. Remove pipe ti'om supply valve.
4. Cut pipe to fit length of assembled fittings and adaptex:
5. Install compression fitting to pipe.
6. Go back to A. Preti_rred Installation section step 4.
NOTE"Above describedmaterialsarenotincludedwiththeproduct.