Manual

InstallationInstructions.
MountingSystemInstallation
Pick a location under the sink to mount the system, i,ocation should be easily accessible, with clearance 1)etween the bottom otthe filter
caniste_ and the floor or bottom of the cabinet; any less will restflt in diflictfl_' of removing filter caniste_ (see Fig. 7). _Mlow enough
space on either side of the s_:stem tot the tubing connections.
SCREWINSTALLATION
I. Remove this template ti'om the manual fin" easier installation.
2. The top of the template openings shotfld be placed a minimum of 17 inches above the bottom ot the cabinet or floor where the
system is to be inounted (Fig. 6 and 7).
NOTE: Any distance lower may result in filter canisters interfenng with the floor when removed
3. Tape template to wall, then mark the wall where the scre_:s are to be installed.
Install scre_:s into the wall, leaving 3/16 inch clearance between the head of the screw and wall (drill pilot holes if needed) (Fig. 8).
5 inches
17 inches Template for screw I_ole pattern on back of filtration system
Fig. 6
Bottomof Cabinetor Floor
Fig. 7
5inches
ews
7 inches
3/16 inch
Screw
\
\
\
\
\
Wall
Fig. 8
/0