Manual

Mounting Bracket to Cabinet Wall
The bracket can be used as a ten@late fin" marking the location of the mounting screx_s. _,\q_en detemfining the location of
the bracket, make sm'e )ou leave ] 1/2" to 2" of free area trader the sumps to allow fin" smnp remoxal and enough space on
either side to make the robing com_ections.
Tubing _._r _
connector
(inlet/
Sump-_}_
Filter I
Filter II
Dual Stage
Tubing
connector
{outlet)
Mounting
screws
_'-_ Sump
2-3/4" ]
Mounting -_
bracket
Tubingconnector..I_'_
(inlet)
Sump._,
Tubingconnector
_._ _utlet/
_'_ Mounting
screws
TubingConnections - Compression Style
_]Rtm the length of the 3/8" robing, c(nmected to the bottom of the
fimcet, to the filter system outlet (illtBtmtion aboxe). Allow enough
slack in the robing so that the refit can be easily returned.
V_ Measm'e and cut the end of the tubing square usim,,_ a shaq_ cutter
LmJ or knife. Remoxe any bm'_ (illustration A).
_] Inspect the end of the tubing, about 1 inch, to be sm'e there are no
impertections. It may be necessar) to cut the robing again.
[_ Slide plastic nut oxer the 3/8" robing.
_] Then slide plastic insert into 3/8" robing.
_] h_sert the plastic tubing all the way to the bottom of the elbow,
Tubing must be fully inserted to avoid leaks,
[_ Slide nut up to the elbow and thread on by hand tmfil fight.
_ Repeat the procedm'e to connect the tubing between the filter system
inlet and the water suppl)/saddle xalxe (illustration in the Installation
Overview section ) .
_]IMPORTANT. Be sure to check fin" leaks at all connections. Tighten as
needed.
IMPORTANE 24 hom_ after instnllation, check fin" an) slow leaks that
Ill;IX' OCC/II; Tighten connections ;is needed,
IMPORTANE If unit is not going to be put into use immediately
mrn off the water supply xalxe.
NOTE: A\oid instnlling the refit where the robing is pulled at a shaq) angle.
This bpe of instnllafion ram' cause the fittings to leak. If using tubing other
than what is supplied, be sm'e it is, hioho qualib'; exact size and rotmdness,
and has a Sillooth S/lI'l_ilCe,
®
®
Cuttubingsquare
%
t I
Y
Endof tubingroundandsmooth,with nocuts,nicks
orflat spots(approximately1 inch)
Tubing
t
f
EIb°w"_" ;i [
Nut,_,- [:3::_
..... J
Tubing
Nut
Head _- Insert
_- Sump
9