Manual

Step-by-stepinstallationinstructions.
Electronic Faucet Installation (not available on all models)
Be sure there is room underneath the sink to make the needed
connections. Select one of the tk)ll()wing places to install the ti_ucet:
---IN an existing sink spray attachment or soap dispenser hole.
_]N a hole to be drilled in the sink top.
_]N a hole to be drilled in the countertop, next to the sink.
NOTEJi,ooking at fimrth illustration at right, be sure the timcet base
will fit flat against the suriilce at the selecmd location so the gasket will
seal. The base inav have to be angled sideways or diagonally.
_]If drilling is needed, make a 1" - 1 1/4" dia. hole. Be sure to use the
proper procedure fordrilling porcelain or stainless steel, Special drill
bits maybe needed,
[] i,ookino at tix_t illustration, insert a screw into the NON_SI,OTTED
base mounting hole. Turn a fiat nut a few turns onto the screw.
_] Posidon the base gasket oxer the mounting hole. Set the base on
the gasket, routing, the leadwire through, the mounting hole.
Holding the fiat nut under the sink with one finge_; tighten the
screw until just snug.
[_ Turn the remaining fiat nut a tew turns onto the other screw.
Posidon the screw in the slotted base motmdng hole and tighten
tmtil snug. Make sure the gasket posidon is properly aligned and
carefullytightenboth screws until the base is held fimflv in place.
Do not overtighten and break the base.
_] Assemble the top timcet base and hex nut onto the timcet stud
(third illustration). Tighten the nut until snug.
_] Insert tubing insert into tubing adapte_: Securely tighten to timcet
stud.
3 " )
_] Feed the length of,/8 O[ tubing fl'om the bottom up through
the timcet base. Connect to the tubing adapter as shown in tourth
illustration, tightening the compression nut securel>
_ Remoxe the short shipping tube and screw the spout into the
thucet body.
_ I,ower the flmcet assembly and lock into place on the faucet base.
Battery Pack Installation and Connection
_]n a dr) location, within reach of the electronic base 3' lead wire,
select a [)lace for the battex_' pack (see illustration on [)age 5).
The battery pack attaches to most sudi_ces, using the included
"stick)q)ack" Velcro T_Istrip.
]The battery pack tlses two size _A batteries. Check to be Stli'e they
are installed correctly. Then remoxe the paper backing
on the Velcro TMstrip and secure the pack in place.
[_] Fasten electronic base lead wire and battery pack connector
together.
Screw(2)
Faucet
base
Nut12}
TOPVIEW
Nut(2)_ Screw(2)
Faucetbase_ _ _4/.- 1" 11/4"dia.
\\ // !r,ou,,t n ho,e
Gasket---_-_ mo_::'tker_rop
Lever
_ Faucet
,_,_ Faucetstud
@%p2ucet
@_e--- Hexnut
-_ Tubinginsert
_ Tubingadapter
_ Compressionnut
Tubinginsert
3/8" tubing,(run
to Filter2 outlet)
Tubingadapter
8
Baseleadwireconnector,_ \ \
(to batten/pack} / \ \