Manual

Step-by-stepinstallationinstructions.
Faucet Installation for Model GNIS15CBL (rev. 2) only
Be sure there is room underneath tile sink to make
tile needed connections. Select one of tile tollowing
places to install tile timcet:
_]N an existing sink spray attachment or soap
dispenser hole.
--IN a hole to be drilled in the sink top.
_]N a hole to be drilled in the countertop, next
to the sink.
Lever
NOTE:I,ooking at second illustration at right, be sure
tile fimcet base will fit fiat against tile surti_ce at tile
selected location so the gasket will seal.
_]If drilling is needed, make a ?/4" to 1" dia. hole.
Be sure to use the proper procedure for drilling
porcelain or stainless steel Special drill bits may
be needed.
Smallgasket
Faucet
stud
Base
ASSEMBLED
[]
Place small gz_sket, base and large gasket (in that
order) onto the fimcet stem. Next, place lock
x_nsher and hex nut onto timcet stud.
_] Insert washer into tubing ada )ter Securely
tighten to ti_ueet stud.
[_ Feed the length of .'4/8 " OD tube fl'om the
bottom uI) through, tile mounting hole.
Connect to tile tubing adapter as shown in
second illust_tion, tightening tile compression
n/It securelv.
_] Remoxe tile short shipi)ing tube and insert
tile spout into tile timcet bod). Rotate spout
into place.
@ I,ower tile thucet assembly into place on tile
tmde_ide of tile mounting hole. Place tile
mounting bracket above the lock washe_:
}\]file holding the mounting bracket in place,
securely tighten the hex nut.
Sink
Large gasket
_J
Lockwasher_
Hexnut_ I
Tubing_,
insert
_Mounting bracket
_ Tubingadapter
_[_'_'_ Compressionnut
Tubing
Compression
Tubingadapter
3/8" tubing,{I
to FilterII outlet}
7