Manual

InstallationInstructions.
Feed Water Supply
Check and comply with local plumbing codes as you plan; then instnll a cold feed water supply fitting. For new
l_ome instnllation using st;mdard phunbing fittings, see fiI_t two illustrations below. A _'pical installation for
existing homes using the saddle \_dve is shown ill third illustration below.
A. PREFERREDINSTALLATION
F_Tum off the cold water suppl):
F_ Comph,ing with phunbing codes, instnll a fitting on tile cold _ater pipe to adapt .'4/8" OD tubin , _ t_/ical
connection is shm_n ill illustrations at right (parts not included). Make sure a x_ater suppl)vahe is used.
water
Preferred water supply connection
(using compression fitting)
Watersupplyvalve
Insert(notincluded)
Ferrule
€
3/8" tubing to inlet
B. OPTIONAL HOME INSTALLATION Where codes permit
*For 1/2" OD or larger metal tubing only.
NOTE: Codes in the state of Massachusetts require installation by a licensed plumber and do not perm# the use of
the saddle valve. For installation, use plumbing code 248-CMR ofthe Commonwealth of Massachusetts.
F_] Turn off the cold water supply and attnch saddle xalxe as shown ill illustration at d ,ht
._DANGERJTo protect yourself from serious injury or fataJ shock, use a battery-powered hmld drill only
to make the hole. DO NOT USE AN ELECTRICDRILL
F_ Close the _ater supply xalxe b) turning the handle clock_ise.
F_ Open the inain water supply ;al;e and se;eral house filucets to purge air fl'oln the s)steln. Close tilucet,s
when water i'[lns Sllloothlx: '
Optionalwatersupplyconnection(usingsaddlevalve)_
*For I/2" OD or larger metal tubing only.
Snugvalveinto
OVERTIGHTEN.
Nut(2) not J Predrill
requiredif holesin i_ 4 1/4"hole Seal makesurethe
clamparethreaded sealisin place
Clair
Somethreads
Tubin(
Tubinc
6
Rubbergasket Compressionnut
Use to connect the tubing