Manual

Before you call for service...
_ Troubleshooting Tips
Problem
Salty tasting or
brown/yellow colored
water after installation
Possible Causes
Unit not sanitized
What To Do
• Complete the Sanitization Procedureson page 14.
• At completion of recharge cgcle (approx.2 hrs),run water
from faucets to purge the salty water.
Low water pressure
Check pressure.
• Drainheight 8' or less,pressureshould be minimum of 20 psi.
• Drainheight above 8', pressureshould be minimum of 50 psi.
Restricted drain hose • Cleanand reconnect hose.
• Check for kinks indrain line.
Brown!yellow
colored water
Unit was idle for a period of time • Complete the Sanitization Procedureson page !4.
Resin beads showing
up in drinking water
and sink
Cracked distributor • Callfor service.
Sounds you might hear Running water from the unit • Thisis normal.
into a drain during recharge
Water has air bubbles Air in sgstemafter installation • Will go awag after it runs for a while.
and is cloudy
Error Code an control Wiring mag have worked loose
in the control
• Seepage 18for details.
• Unplug transformer.
• Removecontrol cover,release clips on side.
• Check for loose/incorrect wiring connections to electronic
board or switch. Reconnectas required.
• Reassemblecontrol cover.
• PluginTransformer.
• Wait six minutes for Error Codeto reappear.
• If ErrorCode reappears,call for service.
Blue light flashing
When power applied Control needs to be programmed • Seethe Programming the Contro! section, page !0.
to the system (a power outage mag have occurred}
If"DAYS TO EIvIpTY'' Low salt level, less than 15 dags • Fillwith salt.
is flashing • Reset salt level.
If"Err" in displag Electrical problem with sgstem • Seepage 18for details.
• Seeprocedure above, Errorcode on control.
24