Manual

Before you call for service...

_ Troubleshooting -tips

Problem Possible Causes What To Do

Salty tasting or Unit not sanitized • Conq)lete the Sanitization Procedures on page 10.

brown/yellow colored • At ('(nnl)letion of recharge, cycle, (apl)rox. _2hLO,_run water

water after installation ti'()m ti_ucets to purge the salty water:

Low water pressure Check px'esstlx'e.

" Drain height 8' or less, pressure shotfld be minimum oI 20 psi.

• Drain height above 8', pressure should be minimum ot 50 psi.

Restricted drain hose • (]lean and reconnect hose.

• Check fin" kinl<s in drain line.

Brown/yellow Unit was idle for a period of thne • (}omplete the Sanitization Procedures on page 10.

colored water

Resin beads showing Cracked distributor • Call tot se_i('e.

up in drinking water

and sink

Sounds you might hear Rm_fing water from the unit • This is hernial.

into a drain during recharge

Water has air bubbles Air in system after installation • _,_]11go away after it rtms fin" a while.

and is cloudy

Error Code on control Wiring may have worked loose • See page 14 fin" details.

hi the control

• UIq)lug ti'anslblmei:

• Remove control cove_; release clips on side.

• Check fin" loose/incorrect wiring connections to electronic

board or swit('h. Reconnect as required.

• Reassemble control cove_:

• Plug in Transfinme_:

• X.Vaitsix minutes t0r Error Code to reappear;

• If Error Code reappeaI_, call fin" service.

Blue light flashing

When power applied Conl*ol needs to be pmgrmnmed • See the Programming the Control section, page 8.

to the system (a power outage may have occurred)

If "DAYS TOEMPTY" Low salt level, less thmi 15 days • Ell with salt.

is flashing • Reset salt lexel.

If "Err"in display l?TJectrical problem with system • See page 14 fin" details.

• See procedure above, Error code on control.