Manual

Service: Manually Advance Recharge Check
NOTE:The cram'el display midst show a steady
dine (ran flash]m_g)_
1_Press the RECHARGE @ button m_d hok] ]m_
fin" three seco]_ds. RECHARGEbegh_s to flash
as the water so{rem_im_gsystem enters the f]]]
cycle of recharge. Remove the brim_ewe]]
cover amid, ush_g a flashlight, obser]e {i]]
water em_ter] m_gthe bri m_e tam_k. If water does
m?ot em?ter the t;mk, look {or am?obstlllcted
m_ozzle, velmH'i, _ill flow plug or brine mbh_g.
See Care and Cleaning of No {4later Softener
System sectiom
2, A_rer observh_g _ill, press the RECHARGE @
H)lltum [o move die water sofreN?im?g system
im_t(_brh_im_g. A slow flow of water to the draim_
wi]] begim Verif\ _brim_e draw f_'om the brim_e
tam]k bv shim_im_ga fias]]]ight ]m_tothe brim_ewel]
a_d obser_i_g a _oticeab]e drop ill the ]]qlli(;[
1eve] over a _ extel_ ded per] od of ti me.
NOTE: Be sure a sah bridge is _ot preventi_g
water f_'om contacting salt. See Care and
cleaning of No water softening system section.
if the water softening system does not draw brine,
check:
nozzle and/or venturi dirty or deli_ctive.
defective nozzle and venmri seal.
nozzle and venturi not seated property
on gasket.
other inner \_dve defect (rotor seal, rotor
and disc, wave washe_; etc.).
restricted drain (check drain fitting and
hose).
NOTE:If water system pressure is low, an
elevated drain hose may cause back pressure,
stopping brine draw.
3.Again, press the RECHARGE @ button to move
the water snitching system into backwash.
I,ook for a fast flow of water ti'om the drain
hose. A slow flow indicates a plugged top
distributm; backwash flow plug or drain hose.
4. Press the RECHARGE@ button to move the
water sofiening s)_stem into fast rinse. Again
look fin" a fast drain flow. Allow the water
soliening system to rinse fin" a few minutes
to flush out any brine that mav remain in
the resin tank fl'om the brining cycle test.
5. To return the water sotiening system to
service, press the RECHARGE @ button.
/C