Manual

About the water softener system.
Service: Electronic Demand TimeFeatures and Service
ERRORCODE
DISPLAYED ERR03 ERR04 ERR05
POSSIBLEDEFECT • Control
ERR01
• Motor
inoperative
• Wiring
harnessor
connection
to switch
• Position
switch
• Control
ERR02
• Position
switch
• Control
• Motor
inoperative
or wiring
harness
• Control
• Position
switch or
wiring
harness
• Control
Toremove an error code: !. Unplug transformer
2. Correct defect.
3. Plug transformer in.
4. Wait for at least 6 minutes. The error code wL!/return ff the reason for
the error code was not corrected
Service: Timer/Softener, Service Checkout Procedure
If you are not getting soft water; and an error
code is not displayed, use the procedures below
to find the i)rol)lem. First make the fl)llowing
visual checks.
VISUALCHECKS:
I. Is there electrical power to the outlet the
water softening system transfi)rmer is
plugged into?
2. Is there sufficient salt in the storage tank?
3. Is the softener bypass wdve directing water
tot soft water service?
4[.Is the valve drain hose open to the drain,
not IllOFe than 8 p above tile so][teneF, and
unobstructed? If hose is above 8', see page 6,
section 4.
If you do not find a problem with the visual checks,
continue below
CONTROLSHOWS I Electricalpowerwasoff.
WRONGTIMEANDDAY, _ Resetthecorrecttimeof
AND/ORSFLASHNG. day.
Checkelectrical _-_"C NOPOWER].__ REPAIRAS
CONTROL_ powerto control [ NEEDED
DISPLAY (outlet,transformer, JPOWEROKI.__ [ CONTROL
BLANK. powercable,all
connections). [ DEFECTIVE
Domanual
diagnostics.
CONTROLDISPLAYSHOWSI
CORRECTTIMEANDDAY -_
AND SSTEADY
I
Investigatereasonfor I
powerloss.
I
Domanual
diagnosticsto
verifyproper
funct on.
/4