Installation Guide

To Use HANDS FREE AUTOFILL:
• Center container on Recess Dispenser Tray as far back as
possible without activating paddle and remove hand from
container
• Press AUTOFILL
To Stop AUTOFILL
• Press AUTOFILL to stop.
Important Facts about AUTOFILL
• For optimum results, use a uniform container between
4-8” tall and 2-6” wide.
• Fill level and functionality may vary on containers taller
than 8” or wider than 6”.
• Container volumes may vary, if error message “Not Found”
is given, try a different container.
• AUTOFILL will time out.
• Handles, straws, and garnishes on the rim of the container
my cause overfilling or variation in fill volumes.
• Splashing may occur depending on the location of the
container, water flow rate, container shape, and ice cubes.
• Keep sensors clean with a clean damp cloth, and do not
spray liquid or cleaners directly on sensors
• AUTOFILL works best with household water pressure of 60
to 100 psi.
• Ice in container may affect fill volume. If issues are
experienced, use less ice.
12
About Autofill.*
Sensors
*Select Models Only
About the K-Cup Brewing System.*
WARNING
Scalding Hazard.
• The water coming from the dispenser is very hot and can
cause scalds or burns. Read all warnings on page 4 prior
to use.
• Do not permit children to use the brewer.
• Always use a container that is suitable for hot liquids
(ceramic, foam, etc.)
• Do not brew into a mug made of glass. Doing so may
cause the glass to crack or break.
• If you live above 5000 feet, press Fridge and Door Alarm
and control will cycle from Low Altitude (Lo AL) to High
Altitude (Hi AL).
• DO NOT use the hot water dispenser immediately after
installing a new water filter as it may result in spurting
of hot water. Dispense cold water for about 5 minutes to
purge air from the system prior to dispensing hot water.
Important Facts about HOT WATER