SDS

GE7000
Page:4/10
Version:
1.3
Date of issue/Date of revision:
09/11/2015
Date of previous issue:
06/26/2015
until ready for use. Containers that have been opened must be
carefully resealed and kept upright to prevent leakage. Do not store
in unlabeled containers. Use appropriate containment to avoid
environmental contamination.
Section 8. Exposure controls/personal protection
Control parameters
Occupational exposure limits
None.
Appropriate engineering controls
:
No special ventilation requirements. Good general ventilation
should be sufficient to control worker exposure to airborne
contaminants. If this product contains ingredients with exposure
limits, use process enclosures, local exhaust ventilation or other
engineering controls to keep worker exposure below any
recommended or statutory limits.
Environmental exposure controls
:
Emissions from ventilation or work process equipment should be
checked to ensure they comply with the requirements of
environmental protection legislation. In some cases, fume scrubbers,
filters or engineering modifications to the process equipment will be
necessary to reduce emissions to acceptable levels.
Individual protection measures
Hygiene measures
:
Wash hands, forearms and face thoroughly after handling chemical
products, before eating, smoking and using the lavatory and at the
end of the working period. Appropriate techniques should be used to
remove potentially contaminated clothing. Wash contaminated
clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Eye/face protection
:
Safety eyewear complying with an approved standard should be
used when a risk assessment indicates this is necessary to avoid
exposure to liquid splashes, mists, gases or dusts.
Skin protection
Hand protection
:
Chemical-resistant, impervious gloves complying with an approved
standard should be worn at all times when handling chemical
products if a risk assessment indicates this is necessary.
Body protection
:
Personal protective equipment for the body should be selected based
on the task being performed and the risks involved and should be
approved by a specialist before handling this product.
Other skin protection
:
Appropriate footwear and any additional skin protection measures
should be selected based on the task being performed and the risks
involved and should be approved by a specialist before handling this
product.
Respiratory protection
:
Use a properly fitted, particulate filter respirator complying with an
approved standard if a risk assessment indicates this is necessary.
Respirator selection must be based on known or anticipated
exposure levels, the hazards of the product and the safe working
limits of the selected respirator. If exposure limits are exceeded or
respiratory irritation is experienced, NIOSH/MSHA approved
respiratory protection should be worn. Supplied air respirators may
be required for non-routine or emergency situations. Respiratory
protection must be provided in accordance with OSHA regulations
(see 29CFR 1910.134).
Use a properly fitted, particulate filter respirator complying with an
approved standard if a risk assessment indicates this is necessary.