SDS

GE5040
Page:5/12
Version:
1.3
Date of issue/Date of revision:
08/03/2015
Date of previous issue:
04/10/2015
Section 8. Exposure controls/personal protection
Control parameters
Occupational exposure limits
Ingredient name
Exposure limits
DIBUTYLTINDIACETATE
OSHA PEL (1993-06-30) Calculated as Sn
Time Weighted Average (TWA) 0.1 mg/m3
NIOSH REL (1994-06-01) Calculated as Sn
Time Weighted Average (TWA) 0.1 mg/m3
OSHA PEL 1989 Vacated (1989-03-01) Calculated as Sn
Time Weighted Average (TWA) 0.1 mg/m3 Form: Organic
ACGIH TLV (1996-05-18) Calculated as Sn
Time Weighted Average (TWA) 0.1 mg/m3
ACGIH TLV (1994-09-01) Calculated as Sn
Short Term Exposure Limit (STEL) 0.2 mg/m3
Appropriate engineering controls
:
If user operations generate dust, fumes, gas, vapor or mist, use
process enclosures, local exhaust ventilation or other engineering
controls to keep worker exposure to airborne contaminants below
any recommended or statutory limits.
Environmental exposure controls
:
Emissions from ventilation or work process equipment should be
checked to ensure they comply with the requirements of
environmental protection legislation. In some cases, fume scrubbers,
filters or engineering modifications to the process equipment will be
necessary to reduce emissions to acceptable levels.
Individual protection measures
Hygiene measures
:
Wash hands, forearms and face thoroughly after handling chemical
products, before eating, smoking and using the lavatory and at the
end of the working period. Appropriate techniques should be used to
remove potentially contaminated clothing. Wash contaminated
clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Eye/face protection
:
Safety eyewear complying with an approved standard should be
used when a risk assessment indicates this is necessary to avoid
exposure to liquid splashes, mists, gases or dusts. If contact is
possible, the following protection should be worn, unless the
assessment indicates a higher degree of protection: chemical splash
goggles.
Skin protection
Hand protection
:
Chemical-resistant, impervious gloves complying with an approved
standard should be worn at all times when handling chemical
products if a risk assessment indicates this is necessary. Considering
the parameters specified by the glove manufacturer, check during
use that the gloves are still retaining their protective properties. It
should be noted that the time to breakthrough for any glove material
may be different for different glove manufacturers. In the case of
mixtures, consisting of several substances, the protection time of the
gloves cannot be accurately estimated.
Body protection
:
Personal protective equipment for the body should be selected based
on the task being performed and the risks involved and should be
approved by a specialist before handling this product.
Other skin protection
:
Appropriate footwear and any additional skin protection measures
should be selected based on the task being performed and the risks