SDS

Material Safety Data Sheet
Version: 1.6
08/06/2009
GE5040
Silicone Rubber Sealant
Page 3/7
EYES
In case of contact, immediately flush eyes with plenty of water for at least 15 minutes and get
medical attention if irritation persists.
NOTE TO PHYSICIAN
Treatment is symptomatic and supportive.
5. FIRE-FIGHTING MEASURES
FLASH POINT:
> 93.3 °C; 200 °F
METHOD:
estimated
FLAMMABLE LIMITS IN AIR - LOWER (%):
no data available
FLAMMABLE LIMITS IN AIR - UPPER (%):
no data available
SENSITIVITY TO MECHANICAL IMPACT:
No
SENSITIVITY TO STATIC DISCHARGE
Sensitivity to static discharge is not expected.
EXTINGUISHING MEDIA
All standard extinguishing agents are suitable.
SPECIAL FIRE FIGHTING PROCEDURES
Firefighters must wear NIOSH/MSHA approved positive pressure self-contained breathing
apparatus with full face mask and full protective clothing.
6. ACCIDENTAL RELEASE MEASURES
ACTION TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED
Wipe, scrape or soak up in an inert material and put in a container for disposal. Wash walking
surfaces with detergent and water to reduce slipping hazard. Wear proper protective equipment as
specified in the protective equipment section.
7. HANDLING AND STORAGE
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
Keep container closed when not in use. Avoid contact with skin and eyes. Remove contact lenses
before using sealant. Do not handle lenses until all sealant has been cleaned from the fingertips, nails
and cuticles. Residual sealant may remain on fingers for several days and transfer to lenses and
cause severe eye irritation. Product releases methanol during application and curing.