MSDS

Material Safety Data Sheet
Version: 1.3
09/04/2007
GE112A 12C-Crtrg (0.730 Lbs-0.331 Kg)
Silicone Rubber Compound
Page 3/8
5. FIRE-FIGHTING MEASURES
FLASH POINT:
> 93.3 °C; 200 °F
METHOD:
estimated
IGNITION TEMPERATURE:
Unknown
FLAMMABLE LIMITS IN AIR - LOWER (%):
Unknown
FLAMMABLE LIMITS IN AIR - UPPER (%):
Unknown
SENSITIVITY TO MECHANICAL IMPACT:
No
SENSITIVITY TO STATIC DISCHARGE
Sensitivity to static discharge is not expected.
EXTINGUISHING MEDIA
All standard extinguishing agents are suitable.
SPECIAL FIRE FIGHTING PROCEDURES
Firefighters must wear NIOSH/MSHA approved positive pressureself-contained breathing
apparatus with full face mask and fullprotective clothing.
6. ACCIDENTAL RELEASE MEASURES
ACTION TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED
Wipe, scrape or soak up in an inert material and put in a container for disposal. Wash walking
surfaces with detergent and water to reduce slipping hazard. Wear proper protective equipment as
specified in the protective equipment section. Increase area ventilation.
7. HANDLING AND STORAGE
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
Use only in well-ventilated areas. Avoid contact with skin and eyes. Eye irritation on contact with the
uncured product. Skin irritation is possible after contact with the uncured product. CAUTION! Remove
contact lenses before using sealant. Do not handle lenses until all sealant has been cleaned from the
fingertips, nails and cuticles. Residual sealant may remain on fingers for several days and transfer to
lenses and cause severe eye irritation. Product releases acetic acid during application and curing. Use
mechanical ventilation to stay below TLV of 10 ppm acetic acid.