Manualshelf

Use and Care Manual

ManualsBrandsGE ManualsPaint10 oz. Silicone Cartridge
12345678
Material Safety Data Sheet
Version: 1.4
03/28/2008
GE510 3TG-Tube (0.198LB-0.090KG)
Silicone Rubber Sealant
Page 6/8
delivery (dystocia). These results were not observed at the 70 and 300 ppm dosing levels. Preliminary
results from an ongoing 24-month combined chronic/oncogenicity study in rats exposed to 10, 30, 150,
or 700 ppm D4 showed test-article related effects in the kidney (male and female) and uterus of rats
exposed for 12 to 24 months. These effects include increased kidney weight and severity of chronic
nephropathy, increased uterine weight, increased incidence of endometrial cell hyperplasia, and an
increased incidence of endometrial adenomas. All of these effects are limited to the 700 ppm
exposure group. The relevance of these data to humans is unclear. Further studies are ongoing. In
developmental toxicity studies, rats and rabbits were exposed to octamethylcyclotetrasiloxane at
concentrations up to 700 ppm and 500 ppm respectively. No teratogenic effects (birth defects) were
observed in either study., Contains dibutyltin compound(s) - May impair fertility. May cause harm to
unborn child.
SENSITIZATION
No data available
SKIN IRRITATION
No data available
EYE IRRITATION
No data available
MUTAGENICITY
Unknown
OTHER EFFECTS OF OVEREXPOSURE
This product contains methylpolysiloxanes which can generate formaldehyde at approximately 300
degrees Fahrenheit (150'C) and above, in atmospheres which contain oxygen. Formaldehyde is a
skin and respiratory sensitizer, eye and throat irritant, acute toxicant, and potential cancer hazard. A
MSDS for formaldehyde is available from Momentive., Additional information on the toxicological
effects of this material or it's ingredients can be found in Section 11 - Toxicological Information.,
Methanol released during curing., Ammonia released during curing.
12. ECOLOGICAL INFORMATION
ECOTOXICITY
No data available
CHEMICAL FATE
No data available
13. DISPOSAL CONSIDERATIONS
DISPOSAL METHOD
Disposal should be made in accordance with federal, state and local regulations.