User Manual

6 49-55122-4
Getting started
USING THE DISHWASHER
Select Options
The light by the selected pad will be lit to indicate which Option has been selected.
Wash
Temp
Boost
(on some
models)
This option increases the temperature to help clean heavily soiled dishes and will increase the
cycle time by 20 to 50 minutes. Option may be turned On or Off during the wash cycle. This
option will also improve dry performance on the Normal cycle.
Steam
Sani (on
some
models)
This option has several functions. Steam is introduced at the beginning of the cycle to help with
heavily soiled and/or dried-on, bakedon soils and for sanitization of dishware along with improving dry
performance by raising the water temperature in the final rinse. The cycle length will vary depending
on the temperature of your inlet water. This option MUST be selected PRIOR to starting the cycle.
Available with Heavy, AutoSense and Normal cycles.
NOTE: This option is monitored for sanitization requirements. If the cycle is interrupted during
or after the main wash portion or if the incoming water temperature is so low that adequate
water heating cannot be achieved, the sanitizing conditions may not be met. In these cases, the
Sanitized light will not illuminate at the end of the cycle. Utilizing this option will modify the cycle
to meet the requirements of Section 6, NSF 184 for soil removal and sanitization efficacy.
NOTE: NSF certified residential dishwashers are not intended for licensed food establishments.
Heated
Dry
This option can be selected by pressing the Dry button once to illuminate the Heated light. This
setting will greatly improve your dry performance for daily, regular or typical dishes. The heated dry
option will typically add 48 minutes to your cycle time. This option is not available with the Rinse
cycle. NOTE: The use of rinse aid can further enhance the dishwasher’s drying performance.
Heated Dry was selected to rate the energy efficiency of this dishwasher.
Dry Boost This option can be selected by pressing the Dry button twice to illuminate the Boost light. This
option will add additional time to your heated dry option, further enhancing the dishwasher’s
drying performance for difficult to dry items. NOTE: The use of rinse aid can further enhance the
dishwasher’s drying performance.
Heated
Dry Off
Shuts off the drying option. Dishes air dry naturally and energy is saved. Opening the door at
the end of the cycle can improve drying performance. NOTE: The use of rinse aid can further
enhance the dishwasher’s drying performance.
Bottle Jets
(on some
models)
This option increases the time that the bottle jets are on and may add up to 23 minutes to the
cycle time. Use this to wash difficult to clean, dishwasher safe baby bottles, sport bottles, tall
coffee cups, etc. See use recommendations in the Loading section.
Wash
Zones
(on some
models)
Selecting either the Upper or Lower Wash Zones will target dishwashing of just one rack. This
will shorten the cycle time and conserve energy. This option should be used when dishes are
placed in only one rack.
Delay
Hours
(on some
models)
Delays the start of a wash cycle up to 8 to 12 hours depending on model. Press Delay Hours, to
select the number of hours, then press Start one time and close door to begin countdown. The
cycle will start once allotted time has expired.
Control
Lock
You can lock the controls to prevent selections from being made. You can also lock the controls
after you have started a cycle to prevent cycle changes. For example, children cannot accidentally
start the dishwasher by pressing pads with this option selected.
To LOCK/UNLOCK the dishwasher control, depending on the model, press and hold the Dry
and Steam pads, or on some models the Select Cycle pad for 3 seconds. The Lock Controls
light, or on some models the Light and Rinse cycle lights will turn on to indicate the control is
locked and will turn off to indicate the control is unlocked.
5