Installation Guide

STEP 1
PREPARATION
Locate the items in the installation package:
• Screws
• Junction box cover
• Drain hose and clamp
• Mounting brackets
• Trim pieces (on some models)
• Drain hose hanger
• Insulation pieces (some models)
• Toekick (pre-installed on some models)
• Owner’s Manual
• Product samples and/or coupons
Dishwasher Installation
STEP 2
CHECK DOOR BALANCE
(CONT.)
CHECK DOOR BALANCE
To check the door balance, hold the top of the
dishwasher firmly.
• Check the door balance by opening and closing the
door.
6
STEP 2
Tip: Make sure door opens and closes smoothly.
Check door opening and closing. If door does not open
easily or falls too quickly, check spring cable routing.
The cable is held in place by “shoulders” on the pulley.
Check to be sure cable has not slipped over the pulley
shoulders and is routed as shown.
Make sure
pulley cable
is within
pulley
shoulders
Front View
Opening the door will cause the
dishwasher to tip forward when it
is not fully installed. When opening
the door prior to the dishwasher
being fully installed, hold the top of
the dishwasher securely with one hand and hold the
door with the other hand. Gloves should be worn.
CAUTION
Abrir la puerta hará que el lavavajillas
se incline hacia adelante cuando
no se encuentre completamente
instalado. Al abrir la puerta antes
de haber instalado completamente
el lavavajillas, sostenga la parte superior del
lavavajillas de forma segura con una mano y
sostenga la puerta con la otra mano. Se deberán
usar guantes.
PRECAUCIÓN
• Door is properly
balanced if,
when opened, it
self closes within
20° from vertical,
stays in position
from 20° to 70°
and falls fully
open beyond 70°.
Door
closes
within
20°
Door stays in
position from
20° to 70°
Door falls fully
open beyond 70°
Side View
NOTE: Springs are not adjustable.