Manual

InstallationInstructions(cent).
Move the compactor close to its final position.
Plug the )ower snpply cord into a properly
gq-ounded receptacle.
Careflllly lift tile [iont slightly and roll
conq)actor into the cabinel openin_ until the
retaining brackets stop the unit.
Using the two #8 -I 8 x 1/2" screws, tasten tile
retaining brackeus to the underskle of the
countertop with the mounting scre_s. If the
t)ra(kets CallllO[ De atfa( h(,d lO [llc underside
of countertop, atlach m<>unting (:lips to
brackets. Fasten +ompactor 1o cal)incl ti-<mt
;\rit[l nlounling screws throngh nlountilag clips.
Retainin9
bracket
i
Retaining_
bracket
Mounting_
0 Grasp sides of cnmpactor dl-awer and place bottom of drawer into U-acks. Lift at the handle so
the fi'ont of drawer will go over drawer stops. Close drawer. Check if drawer ()pens freely. If the
toe plate rubs against floor, see section below.
14
Adjusting the Toe Plate
lfdw lee plate nd_s the floor cow, ring, the toe
plate cleanmcc may bc (:h:mged as lolh _ws:
[_ Mark on each side _ff the toe plale the
anlllnnt o['loe plate dml rubs Ihc tlool
covering.
[_ Remove d_c (Irawt, r honl the trail. See
Step 3.
_[tse ;I ruler aim a IX'rail {n <balk 1+,dlaW a
line between lilt' Illarks on (';R'h side o[toe
plale.
[_] Use scissors or uti]ily knifc to cut loe plate
al<mg line.
[_ Replace drawer. See Step I0. If toe plale
s t )s 1 ( \'cling, Jt.l)Cat these steps