Installation Guide

3 4
Remove cover
AC line
To dimming
controller (optional)
From
luminaire
Install ttings
2
Install driver enclosure to a suitable structural
member using two 1/4-20 screws.
1
Remove driver enclosure cover. Carefully remove
knockout for AC line input wires. Install listed
electrical ttings in the knockout holes for wire
protection.
Connect the black (line), white (neutral) and green
wires of the AC line to the terminal block. Next
connect the red, blue and green wires of the
luminaire to the terminal block.
Replace electrical enclosure cover. Remove
protective lm from the face of the luminaire.
Electrical Connections
1/4-20 screws
Optional dimmer: When connecting dimming
controller, wires must be run through a separate
knockout hole equipped with cable gland suitable
for 20mm hole and separated a minimum of
6.4mm (0.250 in.) from branch circuit wiring.