Installation Guide
2
4
3
On the 1st luminaire, disconnect the right-side
suspension wire and “Y” shape suspension wire.
Then on the 2nd luminaire, disassemble the
left-side “Y” shape suspension wire (this one will
not be used).
Join 1st and 2nd luminaires together by fastening
the brackets on the modied “Y” shape suspension
wire from Step 9. Fasten brackets using four
M8 screws. Screw torque should be between
15.3±0.8kg f.
Attach a bracket to each end of the “Y” shape
suspension wire using washer, spring washer
and M8 nuts. Screw torque should be between
15.3±0.8kg f.
For multiple units installed in series, all canopy sets will have a power cable except the last canopy.
Optional Mounting Method - Connecting Suspended Fixtures in Series
Reattach suspension wire to “Y” shape suspension
wire. To adjust height and to level a xture, squeeze
the tip of the gripper and pull the suspension cable
to the desired height. Clip the cable with cable
cutters to nish the appearance.
5
Squeeze tip to adjust
1st luminaire
Remove “Y” shape wires
“Y” shape
suspension wire
Bracket
Disconnect
suspension wire
2nd luminaire
Canopy set without power cable
Canopy sets with power cable
1