Installation Guide

Unit Installation
To adjust height and to level a xture, squeeze the
tip of the gripper and pull the suspension cable to
the desired height. Clip the cable with cable cutters
to nish the appearance.
Optional: For an improved appearance, electrical
wire can be tie-wrapped to the suspension wire.
Tie wrap
2
Attach bracket bar to junction box in ceiling with
two 8-32 (M4) screws. Repeat on other side.
Connect the black (line) and white (neutral) wires
from the luminaire to the matching-colored wires
from the driver enclosure. Connect both green
wires to the grounding screw.
Canopy
(electrical)
Strain relief
bushing
Wires from luminaire
Suspension cable
Cable coupler
Stud
To driver enclosure
To driver enclosure
Junction box in ceiling
Bracket bar
1
Carefully unpack unit from its packaging. Properly
inspect for defects before installing. Wear work
gloves to prevent dirt and oil from being transferred
to the luminaire.
3
5
4
6
Fit canopy over stud of bracket bar, then screw
cable coupler onto stud.
Squeeze tip to adjust