Installation Guide

Unit Installation
To adjust height and to level a xture, squeeze the
tip of the gripper and pull the suspension cable to
the desired height. Clip the cable with cable cutters
to nish the appearance.
Optional: For an improved appearance, electrical
wire can be tie-wrapped to the suspension wire.
Tie wrap
2
Attach crossbar to junction box in ceiling with two
1/4 inch screws. Repeat on other side.
Connect the black (line) and white (neutral) wires
from the luminaire to the matching-colored
wires from the driver enclosure. Connect both
green wires to the grounding screw. Refer to the
EP-DKIT400UV and EP-DKIT400UD LED Driver
Installation Instructions for more information.
Canopy
(electrical)
Strain relief
bushing
Wires from luminaire
Suspension cable
Cable coupler
Stud
To driver enclosure
To driver enclosure
Junction box in ceiling
Crossbar
1
Carefully unpack unit from its packaging. Properly
inspect for defects before installing. Wear work
gloves to prevent dirt and oil from being transferred
to the luminaire.
3
5
4
6
Fit canopy over stud of crossbar, then screw cable
coupler onto stud.
Squeeze tip to adjust