Installation Guide

a) Grey
b) Violet
c) Green-yellow
AC line
EcoSystem line
Black
e) Orange
d) White
3 4
Connect Driver wires to Lutron interface as follows:
a) Driver 0-10V grey wire to Lutron grey connector.
b) Driver 0-10V violet wire to Lutron violet connector.
c) One green-yellow wire to Lutron green connector.
d) One Driver white wire to Lutron white connector.
e) Driver orange wire to Lutron orange connector.
Push out appropriate size knockout tabs and install
approved conduit connectors for both the AC and
EcoSystem lines.
5 6
Connect AC line to black, white and green wires from
Lutron interface with twist-on wire caps. Connect
EcoSystem bus wires to the two purple Lutron
connectors (Link E1 and E2).
Next connect the luminaire wires to the blue and red
wires of the power supply. Connect the green wires to
the ground screw.
After completing connections, replace enclosure cover
and screw down M4 screws and lock washers. Make sure
screws are tight and cover is secured.
E1 and E2