Installation Guide

Lighting Solutions

Installation Guide

GESK01 Slanted Ceiling Mount Kit

GESK02 Seismic Bracing Kit

Lumination

LED Luminaires

Remove aircraft cable from gripper by squeezing

the top. Then remove cable from cable coupler.

Fit canopy over stud of crossbar, then screw

cable coupler onto stud. Repeat Step 1 to Step 3

on other side.

Feed aircraft cable through slanted cable coupler

and gripper.

Installed.

Remove cable coupler

Junction box

installed into

slanted ceiling

Stud

Squeeze gripper

to release cable

imagination at work

Installation: Slanted Ceiling Mount Kit

PAGE 1
Installation Guide GE Lighting Solutions Lumination LED Luminaires TM GESK01 Slanted Ceiling Mount Kit GESK02 Seismic Bracing Kit Installation: Slanted Ceiling Mount Kit Remove cable coupler Squeeze gripper to release cable 1 Remove aircraft cable from gripper by squeezing the top. Then remove cable from cable coupler. 2 Feed aircraft cable through slanted cable coupler and gripper. 4 Installed.
PAGE 2
Installation: Seismic Bracing Kit Bracing cables Attach clamp 6 inches Mount to wall or ceiling Bracing cable 1 Attach bracing cables clamp about 6” above the Y-cable for both ends. 3 Installed. 2 Anchor the Side Cable Exit Gated Hook (4 pieces) to wall or ceiling. GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com 1-888- 69- 43-533 GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. Lumination is a trademark of GE Lighting Solutions, LLC.