Installation Guide

MOUNTING
3
WARNING
Risk of injury or damage. Unit will fall if not installed
properly. Follow installation instructions.
HANDLING
2
• This luminaire has been properly packed so that no
parts should have been damaged during transit.
• Inspect to conrm.
• Damage may occur if luminaire is improperly handled
outside of pack.
• Do not impact or stack luminaire after removal from
packaging.
UNPACKING
1
• I. 6-inch Arm
• II. Slip-Fitter “E” mount
Slip-Fitter mounts to 2-inch pipe (2-3/8” OD).
Install Luminaire on pipe and tighten each
mounting bolt to 10-12 foot-pounds,
alternating between bolts.
B. Mount frame and nut plate assembly to pole with (2)
3/8” bolts and lockwashers. If a round pole, install
Round Pole Adaptor.
C. Attach luminaire to frame feeding power leads
through Frame tube. Secure with (2) 3/8” bolts a
lockwashers.
D. Install cover over Frame and secure with #8-32
Screw.
E. Splice power leads to incoming power. Install pole
cap.
Strain relief for incoming power must be provided in the
pole top by the customer.
Step 1
A. Drill pole per Fig. A if a square pole or Fig. B if a round
pole.
WARNING
DO NOT REMOVE TETHERS FROM UNIT TO PREVENT
DAMMAGED TO DOOR ASSEMBLY.
• To open Light Engine Door loosen both fastners CCW.
Cover
Cover
Luminaire
Nut
Plate
Frame
#8-32 Screw
Power Leads
3/8” bolts
& Lockwashers
GE_GEH-6019 _AreaLightingEvolve_LED_EADC_Installation_FINAL_EngFre_062513.indd 2 6/25/2013 12:50:44 PM