Installation Guide

35-201578-135 (12/03)
CAUTION
Risk of burn
• Allow lamp/fixture to cool before
handling
WARNING
Risk of burn
• Do not touch operating luminaire
TRUNNION UNITS
1. Open the glass door.
NOTE: Door may be removed by opening approxi-
mately 190°, lifting up slightly and sliding to the
right.
2. Remove protective insulation shield.
3. Make electrical connections to cord or leads in slipfitter wiring
box.
4. Reposition protective insulation shield.
5. Close and secure door.
TENON PIPE UNITS — Open wiring compartment cover
located on the mounting bracket. Make electrical connec-
tions and close wiring compartment cover.
LAMPS
Use only lamps specified on nameplate. Observe
lamp manufacturer’s recommendations and
restrictions on lamp operation, particularly ballast
type, burning position, etc. Replace blackened lamps
immediately.
Lamp Tightness – Mogul Base Lamp: The lamp should be
securely inserted to the NEMA-EEI specified torque of 35
inch-pounds, which is best achieved by very firmly tightening
to insure application of sufficient torque. Tightening must be
sufficient to fully depress and load the center contact of the
socket.
Note: Use of lubricants on lamp base or socket can cause
rapid lamp failure and voids fixture warranty.
MAINTENANCE
Periodic cleaning on the outside of the door glass will
ensure operation at maximum optical efficiency. The glass
and reflector (if needed) should be cleaned with non-
abrasive soap, cleaner, or detergent solutions, rinsed with
cold water and wiped dry.
The light output is also dependent on the age of the lamp.
In applications where the light level is critical, it may be
desirable to replace lamps before they burn out. The lamp
manufacturer can provide data showing how the lamp light
output decreases with use.
g
GE Lighting Solutions is a subsidiary of the General Electric Company. Evolve and other trademarks belong to GE Lighting Solutions. The GE brand and logo are trademarks of the General Electric Company.
© 2011 GE Lighting Solutions. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com
16943533----888