Brochure

F-42/2008
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com
1 - 8 8 8 - 6 9 - 4 3 - 5 3 3
FLOODLIGHTING ACCESSORIES
REFER TO ACCESSORY INDEX TO MATCH ACCESSORY WITH PRODUCT.
ILLUSTRATIONS SHOWN ARE TYPICAL REPRESENTATIONS.
REMOTE BALLASTED POWER SPOT III FLOODLIGHT
WITH OR WITHOUT GLARE CONTROL
OPTICAL/LAMP HOLDER SELECTION TABLE
Maximum
Separation,
Light Ordering Optical and
Wattage Source Number Ballast
200, 250, 400 HPS PSFC40S 10ft (3M)
750 HPS PSFC75S 10ft (3M
1000 HPS PSFC01SC034 10ft (3M
400 Metal Halide PSFC40M NOTE*
1000/1500 Metal Halide PSFC95M NOTE*
NOTE: *No limitation except voltage drop in the cable must not
exceed five volts.
INDOOR APPLICATION
HPS lamps (seperated from ballast 10 feet (3 meters) or
less) or metal halide lamps.
(Figure 1) - choose one Ordering Number each from
STEPS 1, 2, 3, 4, and 5:
•STEP1.From Floodlight Component page F-46, select
an Ordering Number for Optical Component for Power
Spot floodlight or Powr Spot floodlight or Powr Spot
floodlight with glare control.
EXAMPLE: PSFBDHD0
PSFGCHD0
•STEP2From Optical/Lamp Holder Selection Table, se-
lect an Ordering Number for Powr Spot floodlight (same
for both products). See Figure 2 for dimensions of Powr
Spot floodlight page F-36 for dimensions of glare con-
trol assembly.
EXAMPLE: PSFC95M
•STEP3From Industrial component page I-145 select
Ordering Number for Ballast Component of Filterglow
EXAMPLE: FG6G01M0AN11
OTPICAL A DIA. B C RADIUS D MIN.
22 in. 23.000 in. 13.000 in. 9.000 in. 26.500 in.
559mm 584mm 330mm 229mm. 673mm
20 in. 21.000 in. 13.000 in. 9.000 in. 26.000 in.
508mm 533mm 330mm 229mm 660mm
Figure 1
Figure 2
Figure 3 FG6 Large Ballast Housing
STEP 2 - Optical/lamp Holder
STEP 4 - Male Connector
STEP 1 - Optical
STEP 3 - Ballast
STEP 3 -
Ballast
Mounting
Bracket
Wire by
Customer
Cord Diameter
0.500” - 0.625”
14.00”
(355.6mm)
13.750”
(349mm)