Use and Care Guide

49-2000062 7
Stainless Steel Surfaces (on some models)
Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the brush line. Follow
the cleaner instructions for cleaning the stainless steel
surface. Cleaners with oxalic acid such as Bar Keepers
Friend Soft Cleanser™ will remove surface rust,
tarnish, and small blemishes. Use only a liquid cleanser
free of grit and rub in the direction of the brush lines with
a damp soft sponge.
To inquire about purchasing stainless steel appliance
cleaner or polish, or to find the location of a dealer
nearest you, visit cafeappliances.com/parts.
Painted Surfaces (on some models)
Do not use a steel wool pads or other abrasive
cleaners; they will scratch the surface.
Clean grease-laden surfaces of the hood frequently. To
clean the hood surface, use a hot, damp cloth with a
mild detergent suitable for painted surfaces. About one
tablespoon of ammonia may be added to the water. Use
a clean, hot, damp cloth to remove soap. Dry with a dry,
clean cloth.
NOTE: When cleaning, take care not to come in contact
with filters and other surfaces.
CAUTION
When cleaning the hood surfaces,
be certain that you do not touch the light with moist
hands or cloth. A warm or hot light may break if
touched with a moist surface. Always let the light
cool completely before cleaning around it.
Surfaces
CARE AND CLEANING: Surfaces / Lights
CAUTION
Allow lights to cool before touching.
To change the lights:
1. Before attempting to replace the lights, make sure that
the light switch is turned off.
2. Wear gloves. Do not touch the light with your bare
fingers. Skin oils can cause early light failure. Wear
clean gloves or use a paper towel to handle the light.
3. Using a flathead screwdriver, unclip the metal trim ring
from the lighting support.
4. Remove the light by pulling towards the front of the
hood. Replace it with a new G4 20W Clear Halogen
Capsule light by inserting the two stakes into the holes
and pushing towards the back of the hood to secure
the light.
5. Reinsert the metal trim ring by lining up the two side
holes on the lighting support with the two tabs on the
trim ring, and push upward.
Lights