Installation guide

22
ADAPTING MICROWAVE BLOWER
FOR RECIRCULATION (cont.)
C4.
Installation Instructions
NOTE: When mounting
the microwave oven,
thread power cord
through hole in bottom of
top cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift oven
E\SXOOLQJFRUG
/LIWPLFURZDYHWLOWLW
forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.
2
Rotate front of oven
up against cabinet
bottom.
1
Close the blower door. Slide blower shield onto
the top of the blower door opening.
Remove the metal vent fan cover on the back of
WKHPLFURZDYHE\VOLGLQJLWXS
7
6
MOUNT THE MICROWAVE
OVEN
C5.
FOR EASIER INSTALLATION
AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE:,I\RXUFDELQHWLVPHWDOXVHWKHQ\ORQ
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from
overtightening screws.
Back of
Microwave
Oven
Blower
Retaining
Screws
Blower Retaining
Screw
Secure the blower to the microwave using the
blower retaining screws from Step 1.
8
CAUTION