Installation guide

20
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
C2.
RECIRCULATING (Non-Vented Ductless)
INSTALLATION OVERVIEW
C1.$WWDFK0RXQWLQJ3ODWHWR:DOO
C2.3UHSDUH7RS&DELQHW
C3. Check Blower Motor Orientation
C4. Adapt Blower for Recirculation
C5. Mount the Microwave Oven
C6. Install Charcoal Filter
 5HDGWKHLQVWUXFWLRQVRQWKH723&$%,1(7
7(03/$7(
 7DSHLWXQGHUQHDWKWKHWRSFDELQHW
• Drill the holes, following the instructions on the
723&$%,1(77(03/$7(
Wear safety goggles when
drilling holes in the cabinet bottom.
Installation Instructions
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
C
 3ODFHWKHPRXQWLQJSODWHDJDLQVWWKHZDOODQG
insert the toggle wings into the holes in the wall
to mount the plate.
127(%HIRUHWLJKWHQLQJWRJJOHEROWVDQGZRRG
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed
IOXVKDJDLQVWWKHZDOODQGWKDWWKHSODWHLVSURSHUO\
centered under the cabinet.
Be careful to avoid pinching
fingers between the back of
the mounting plate and the wall.
 7LJKWHQDOOEROWV3XOOWKHSODWHDZD\IURPWKHZDOO
to help tighten the bolts.
3
4
Wall
Mounting
3ODWH
Spacing for
7RJJOHV0RUH7KDQ
:DOO7KLFNQHVV
Bolt End
7RJJOH
Bolt
7RJJOH:LQJV
To use toggle bolts:
ATTACH THE MOUNTING
PLATE TO THE WALL
C1
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud. Recommended locations on the mounting
SODWHDUHLQGLFDWHGE\$%&DQG'
Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through
WKHKROHVGHVLJQDWHGWRJRLQWRGU\ZDOODQG
reattach the toggle wings to
3
»4s onto each bolt.
1
2
A
B
C
D
CAUTION
CAUTION