Installation guide

Installation Instructions
I- PLACEMENT OF THE MOUNTING PLATE
N REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
_ Remove the installation instructions, filters, glass
tray and the small hardware bag. Do not remove
the Swrofl)am protecting the fl'ont of the oven.
[] Fold back all 4 carton flaps flflly against carton
sides. Then careflfllv roll the oven and carton over
onto the top side. m'he oven should be resting in
the Stvrofl)am.
_Pull the carton up and off the oven.
[] Remove and properly discard plastic bags.
Mounting
Plate
!
i
[]Remove the 2 screws from the mounting plate.
This plate will be used as the rear wall template
and for mounting. You max discard these screws.
N FINDING THE WALL STUDS
_ Center
_Find the studs, usino one of the followiw,
methods:
A. Stud finder - a magnetic device which
locates nails.
OR
B. Ilse a hammer to tap lightly across the
mounting surihce to find a solid s(mnd.
This will indicate a stud location.
_ After the stud find tile bylocating
(s), centel"
probing the wall with a small nail to find the edges
of the stud. Then place a mark haltway between
the edges. Tile center of any ac!jacent studs should
be 16" or 24" fl'om this mark.
_Draw a line down the center of tile sttlds.
THE MICROWAVE MUST BE CONNECTED TO
AT LE&ST ONE WALL STUD.
8