Installation guide

Installation Instructions
ADAPTING MICROWAVE
BLOWER FOR
RECIRCULATION {cont.)
[]Guide tile wire do_n into tile blower o )ening so it} ,
rests securel) in front of tile blo_er.
[]Secure blower unit to microwaxe with tile screw
remoxed in Step 4.
[]Replace blower plate with tile screw remoxed in
Step 1.
MOUNT THE MICROWAVE
OVEN
FOIl EASIER INSTAI,IATION AND PERSONAl,
SAFETY, X,VERECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If yore" cabinet is metal, use the nylon
grommet around tile power cord hole to prevent
cutting of tile cord.
NOTE: We recommend using filler blocks if tile
cabinet fl'ont hangs below tile cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from overtightening
screws.
NOTE: When mo/mting
tile illicYowave oven_
thread power cord
through hole in bottom of
top cabinet, Kee I) it tight
throughout Steps 1-3. Do
not pinch cord or lilt
oxen by )ullino cord._
• I &
_I,ifl microwave, tilt it
fin'ward, and hook
slots at back bottom
edge onto t()/li" lower
tabs of mounting
plate.
_ Rotate front of oxen
up against cabinet
bottoin,
_lnsert a sell'aligning screw through top center
cabinet hole. Temporarily secm'e the oven by
turning tile screw at least two full turns after tile
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet,
CabinetFront
CabinetBottomShelf
FillerBlock
i_oEquivalent to Depth
f CabinetRecess
Self-AligningScrew
MicrowaveOvenTop
_Attach tile microwaxe oxen to tile top cabinet.
21