Installation guide

Installation Instructions

CHECK MICROWAVE ASSEMBLY

Exhaust Adaptor (absent

on models shipped for

recirculation exhaust).\

i__ _ _ack of ,

EXT- M,cr°wavei

" Place tile microwave in its upright position, with tile

top of tile trait facing up.

" Tile microwave oven may be shipped assembled for

top exhaust (adaptor installed) or fin" recirculation

exhaust (adaptor absent).

• If tile microwave was shipped for recirculation

exhaust, skip to C5. If shipped fin" top exhaust,

proceed with C4.

ADAPTING MICROWAVE

BLOWER FOR RECIRCULATION

_ Remo_e Damper [] I,ift off tile

and save _ _, blower

screw that plate and

holds . - "" ° attached

blower adaptor

plate to { fl'om tile

Ill icFowave. ', illicrowave.

Back of ,

-_ Microwave '

_ Slicle exhaust adaptor to one side and remo_e it.

NOTE: Tile exhaust adaptor with damper is not

needed for recirculating models. You may want to

sa',e theln for possible fllture use.

_ Remoxe and tile that holds tile blower

sa'_e screw

inotoi" to tile illiCi'owa_e.

_ Blower Plate

,,_ Back of

Microwave

_ Carefully pull out tile blower unit. Tile wires

will extend tar enough to allow xou to adjust tile

blower trait.

• ( o

_Roll tile blower rant .)0 so that tim blade openings

are lacing toward tile front of tile microwaxe.

_011

_ Place tile blower trait back into tile o )enino[ &"

CAUTION: Do not pull or stretch the blower unit

wiring, Make sure the wires are not pinched,