Installation guide

Installation Instructions
I-_ USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes fl)r the top SUl)port screws, a
hole large enough for the power cord to fit throu ,h
and a cutout large enough for the exhaust adaptor.
%
" Read the instructions on tile TOP CABINET
TEMPLATE.
" Tape it tmderneath the top cabinet.
" Drill the holes, following the insnuctions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
I-_ CHECK FOR PROPER
DAMPER OPERATION
BlowerPlate
Exhaust Adaptor
(absenton modelsshipped
for recirculationexhaust)
Damper
Backof
Microwave
" Place tile microwave in its uI)right position, with tile
top of tile unit tacing up.
" This microwave oven mav be shil)ped assembled for
top exhaust (adaptor installed) or fl)r recirculation
exhaust (adaptor absent).
" Make sure tape securing damper is removed and
damper pivots easily before mom_ting microwave.
" You will need to make ac!jUStlnents to assure proper
alignment with yore" house exhaust duct atter the
microwave is installed.
MOUNT THE MICROWAVE
OVEN
FOIl EASIER INSTAI,IATION AND PERSONAI,
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use tile nylon
grolnu/et _li'O/lnd tile power cord hole to l)revent
cutting of tile cord.
NOTE: We recommend using filler blocks if tile
cabinet fl'ont hangs below tile cabinet bottom shelf.
IMPORTANT: If filler blocks are
not used, case damage may occur from
overtightening screws.
NOTE: When motmting
tile ulici'owave ovell_
thread power cord
through hole in bottom of
top cabinet. Kee I) it tight
throughout Steps 1-3. Do
not pinch cord or lift
oxen by pulling cord. \
_ I,if't microwaxe, tilt it
forward, and hook
slots at back bottom
edge onto [()/lI" lower
tabs of mounting
plate,
_Rotate fI'Ollt of
o_en
up against cabinet
bottoI//.
_lnsert a sell=aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns atter the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
13