Installation guide

Installation Instructions
ALIGNING THE WALL PLATE
CAUTION: _,_ar glo_es
to a_oid cutting finge_ on
sharp edces
O "
,
o-,:)OoOo OoOoyoOoOoOo °o°o°oOo
AreaE H01eD
¢
/
-'-'- HoleB J
/
[]Draw a vertical line on the wall at the center of the
30" wide space.
_Use the moui_ting plate as the template for the rear
wall. Place the motmting plate on the wall, making
sure that the tabs are touchhag the bottom of the
cabinet or the level line drawn in Step C for cabinets
with front overhm_g. Line up the notch and centerline
on the bottom of the mounting plate to the centerlhle
on the wall.
_ \._]file holding the mounting plate with one hand,
draw drcles on the wall at holes A, B, C and D
(see illustratioi_ above/actual plate marked with
arrows). Four holes must be used for mounting.
[]
NOTE: Holes C and D are inside area E. If neither
C nor D is in a stud, find a stud somewhere in area E
"and draw "afilth circle to line up with the stud. It is
important to use at least one wood screw mortared
f'trmly in a stud to support the weight of the microwave.
Set the mounting plate aside.
Drill holes on the circles. If there is a stud, drill a :_A_,"
hole fi:,r wood scre_:s. For holes that don't line up with
a stud, chill a %" hole fin" toggle bolts.
NOTE: DO NOT MOUNT THE PLATE AT THIS
TIME.
10