Quick Specs

Specification Revised 1/17
CV M1790SS
GE Cafe
™
Series 1.7 Cu. Ft. Convection Over-the-Range Microwave Oven
Listed by
Underwriters
Laboratories
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
Duct Equivalent Feet
A. Rectangular-To-round
Transition Adaptor 5 ft.
B. Wall Cap 40 ft.
C. 90° Elbow 10 ft.
D. 45° Elbow 5 ft.
E. 90° Elbow 25 ft.
F. 45° Elbow 5 ft.
G. Roof Cap 24 ft.
Filler Panel Kits
JX36BSS-Stainless Steel
When replacing a 36" or
42" range hood, this kit fills
in the additional width to
provide a custom built-in
appearance.
For installation between
cabinets only; not for
end-of-cabinet installation.
Each kit contains two
3"-wide filler panels.
Filter Kits
JX81D–Recirculating
Charcoal Filter Kit
To be used when
the Spacemaker
microwave oven
cannot be vented
to the outside.
HOOD EXHAUST DUCT: Outside ventilation requires a
HOOD EXHAUST DUCT. Read the following carefully.
EXHAUST CONNECTION: The hood exhaust has been
designed to mate with a standard 3-1/4" x 10" rectangular
duct. If a round duct is required, a rectangular-to-round
transition adaptor must be used. Do not use less than a
6" diameter duct.
REAR EXHAUST: If a rear or horizontal exhaust is to
be used, care should be taken to align exhaust with space
between studs, or wall should be prepared at the time it
is constructed by leaving enough space between the wall
studs to accommodate exhaust.
MAXIMUM DUCT LENGTH: For satisfactory air
movement, the total duct length of 3-1/4" x 10"
rectangular or 6" diameter round duct should not exceed
140 equivalent feet.
ELBOWS, TRANSITIONS, WALL AND ROOF CAPS:
etc., present additional resistance to airflow and are
equivalent to a section of straight duct which is longer
than their actual physical size. When calculating the total
duct length, add the equivalent length of all transitions
and adaptors plus the lengths of all straight duct sections.
The chart on the right shows the approximate feet of
equivalent length of some typical ducts.
OPTIONAL ACCESSORIES
(AVAILABLE AT ADDITIONAL COST)