Installation guide

Installation Instructions
TOOLS YOU WILL NEED
# i and #2 Phillipsscrewdriver
Pencil
Tinsnips(for cutting
damper,if required)
Gloves
Safetygoggles
Scissors
(to cut template,
if necessary)
Saw(saber,holeor keyhole)
Ruleror tape measure
raight edge
Electric drill with Y/', V/',
W' and s/8"drill bits
0
Stud finder or
1
Hammer(optional)
Level
Carpentersquare
(optional)
¢5b
Fillerblocksor scrapwood
pieces,if needed
for top cabinetspacing
(usedon recessedbottom
cabinet installationsonly)
Duct and maskingtape
MOUNTING SPACE
lS" max.
66" or more
from the floor
to the top of
the oven
e
Bottom edgeof
cabinet needsto
be30" or more
fromthe cooking
surface
Backsplash
NOTES:
, The space between the cabinets must be 30" wide
and free of obstructions.
If the space between the cabinets is greater than
30", a Filler Panel Kit may be used to fill in the gap
between the oven and the cabinets. Your Owner's
Manual contains the kit number for your model.
This oven is for installation over ranges up to
36" wide.
, If you are going to vent your oven to the outside,
see Hood Exhaust Section for exhaust duct
preparation.
, When installing the oven beneath smooth, flat
cabinets, be careful to follow the instructions
on the top cabinet template for power cord
clearance.
. Maximum cabinet depth above and beside the unit
is 13".
, For models with top venting holes: Do not allow
cabinetry or other objects to block the airflow of the
vent.
, The product should not be installed over any
cooktop or range with a combined BTUgreater
than 60000 BTU.