Installation guide

Installation Instructions

_ ALIGNING THE WALL PLATE

Hole

Draw a Vertical

Line on Wall

_--- from Center of

Top Cabinet

Hole C

ACAUTION'.

Wear glovestoavoidcutting

fingerson sharpedges.

olo

4 T

AreaE J

[] Draw a vertical line on the wall at the center of the 30"

wide space.

[_ Usethe mounting plate as the template for the rear wall.

Placethe mounting plate on the wall, making sure that

thetabsaretouchingthebottomofthecabinetor

thelevellinedrawn inStepC forcabinetswithfront

overhang.Lineup thenotchand centerlineon

themountingplatetothecenterlineon thewall.

[_ While holding the mounting plate with one hand, draw

circles on the wall at holes A, B,Cand D (see illustration

above/actual plate marked with arrows). Four holes

must be used for mounting.

NOTE: Holes C and D are inside area E.If neither C nor D

is in a stud, find a stud somewhere in area Eand draw a

fifth circle to line up with the stud. It is important to use

at least one wood screw mounted firmly in a stud

to support the weight of the oven.

Set the mounting plate aside.

WAR NIN G:Riskofelectricshock.Cancause

injury or death. Take care to not drill into electrical wiring

inside walls or cabinets.

[_ Drill holes on the circles. If there is a stud, drill a sad'hole

for wood screws. For holes that don't line up with a stud,

drill a %" hole for toggle bolts.

NOTE:DONOTMOUNTTHEPLATEATTHISTIME.